cjay904
Gear Grinder
I did a search and found some good advise. I still have questions.
I have a new sender and new gauge. I have the ground to the sending unit very strong as well as to the gauge. When I attached th ignition hot wire to the 12v pole, it reads as full. As soon as I attach the wire from the sender, it reads empty. I guess my question is about where to start troubleshooting? Thanks in advance.
Jay
I have a new sender and new gauge. I have the ground to the sending unit very strong as well as to the gauge. When I attached th ignition hot wire to the 12v pole, it reads as full. As soon as I attach the wire from the sender, it reads empty. I guess my question is about where to start troubleshooting? Thanks in advance.
Jay
