Matt-Lagusis
Bigger Hammer
So I just picked up a 51 Jeepster for my wife. The PO changed the rear end and motor/trans. Currently had a Chevy 6 and 3 Speed OD. Pulling the 6 for a SBC v8 and TH350 trans. Keeping the rear end and am switching the front end to a Mustang 2 set up.
Are there any words of advice from those who have gone down this path? I was looking at a hub to hub kit from Southern Rods. Added the website below. Is there a better kit any of you would recommend?
Going to start a build thread in the next few weeks.
Are there any words of advice from those who have gone down this path? I was looking at a hub to hub kit from Southern Rods. Added the website below. Is there a better kit any of you would recommend?
Going to start a build thread in the next few weeks.
Mustang II Complete Hub to Hub IFS Kit Crossmember Fits Universal 56” Track Width
This is a brand-new complete Mustang II front end suspension that fits Universal 56” Track Width. This kit is a complete Hub to Hub and includes the highest quality components for a complete installation. The crossmember is designed to weld onto vehicle that fits Universal 56 Inch Track Width...
www.southernrods.com