Latest activity

Does anyone here have any thoughts about these seat belts? I'm thinking about installing them in my 59 truck...

Even in my alternate Universe, I don't understand how an L6-226 could be rebuilt for $2000. Two thousand sounds like a reasonable cost...

I am surprised at the majority is reluctant of learning new things, wiring is a skill that has to be learned but it is very...

I understand that I'm in the minority here, but I prefer to make my own harnesses to factory spec's but with safer modern wire that...

It's windy in Kansas as well. And HUMID. I rewired my 50 Jeepster, 6 volt system from fron to back. I built my own harness, and used 12...

When I purchased my first plane, 22 years ago, it was an experimental built by the previous owner and in annual so I could fly it. The...

Finally got my roof on, I used panel bonding adhesive and spot welds still have to clean a few of those up. I did this last weekend I...

AJ's got the same expression I had the first time I laid eyes on a Jeep...

A good vendor I use is www.wireandcableyourway.com They carry the Marine stuff and just about anything you could want. Most is UL...

The great part about using Marine Type 3 wire and connectors is everything is of superior quality. Next to sinking, a boat fire caused...

I did exactly what you are asking here, and built my own harness. My first attempt was very crude and full of bad connections and...

Good morning, you can use the same gauge wires as the original. One of the first things my truck did for me was to sacrifice and burn...

Good Job everybody and a Shout out to Don for starting this thread. The next best thing to being around your Willys is seeing Good pictures!

On most engines that I've worked on, crankshaft endplay is only a few thousands of an inch. If you can literally see the flywheel and...

this was my attempt to copy the green original I posted previously. Also, I couldn't go with the original hardboard and no padding so...